Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Bbk_Bbk

Search: Search took 0.00 seconds.

  1. Replies
    8
    Views
    1,088

    This isnít going my way haha. Note I canít remove...

    This isnít going my way haha. Note I canít remove the dust cap, it appears the bearing is spinning with the dust cap as I try to twist it off the threads. Does anyone have experience with this?
    ...
  2. Replies
    8
    Views
    1,088

    Well I adjusted it just until the radial play (...

    Well I adjusted it just until the radial play ( in and out ) was gone. Which was about 1/8Ē movement of the adjustment pin. And the spindle was smooth and free. But upon sitting it began tightening. ...
  3. Replies
    8
    Views
    1,088

    I watched a video and the fella did the same...

    I watched a video and the fella did the same thing I did, with no issue. I tried getting the spindle out to inspect but Iím having a tough time. Iíll post a video to show what I followed, I have the...
  4. Replies
    8
    Views
    1,088

    Well Iíll post photos once I understand how to...

    Well Iíll post photos once I understand how to properly do it.

    Ok so the spindle has a small amount of radial play, so following the instructions, I carefully moved the pulley back, removed the...
  5. Replies
    8
    Views
    1,088

    Schaublin 70 refurb

    So I recently had the chance to pick up a schaublin 70 at a decent price. Problem is, the lathe had been sitting under a water leak for a while, so thereís some rust.

    However when I looked at it,...
Results 1 to 5 of 5