Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: racasey

Search: Search took 0.00 seconds.

  1. Happy too reply. Sorry for the delay. I...

    Happy too reply. Sorry for the delay.

    I believe the images below are self explanatory.
    Ciao,
    Dick C

    293356

    293357
  2. Thanks all for your thoughtful guidance. This is...

    Thanks all for your thoughtful guidance. This is a big help, and the information you have provided is much appreciated.
    Ciao, DC
  3. Which Series Letter is this 1940 13" x 6' lathe?

    I purchased this lovely lathe in Seattle @ 1975. It was lightly used in an electric motor shop, mainly for turning commutators. It has served me well for 45 years, model making, restoring...
  4. Thank you Gentlemen for the detailed answers. I...

    Thank you Gentlemen for the detailed answers. I have a better understanding of the repair at hand.

    Ciao, DC
  5. Any suggestions???

    Any suggestions???
  6. Repair worn bearing seat in aluminum alloy engine casting

    Gentlemen: I'm a Brit bike buff and need some help on best way to repair a worn bearing seat on a 1950s circa Matchless G80 500cc single. The drive side of the flywheels is supported in two deep...
  7. Replies
    17
    Views
    3,146

    Thanks all. You have certainly given me some...

    Thanks all. You have certainly given me some excellent options.

    Ciao,
    Dick C.
  8. Replies
    17
    Views
    3,146

    improving bearing 'Fit' in a U-Joint

    I need to replace the cross in a u-joint on a circa 1984 Moto Guzzi drive shaft. The cross is 20x44 mm and is retained in the yokes by Seeger snap rings. This shaft is not readily available as a new...
Results 1 to 8 of 8