Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Itstallion

Search: Search took 0.00 seconds.

  1. Replies
    14
    Views
    2,013

    Well here's where it's at today. I'm going to...

    Well here's where it's at today. I'm going to continue with my pattern of scraping until I get that edge in. I realize this is probably overkill for a gib, but it's my practice piece....
  2. Replies
    14
    Views
    2,013

    Hi Paolo, Here are some shots of a pass on it....

    Hi Paolo,

    Here are some shots of a pass on it. I'm probably not putting enough umph into and it's probably taking me 3 times as long.

    Thank you!
    Mark...
  3. Replies
    14
    Views
    2,013

    Well following the advice and the procurement of...

    Well following the advice and the procurement of some diamond hones I think it's coming in. It's obvious during the roughing stage that I rounded over the edges pretty good. I'm using a 60 radius...
  4. Replies
    14
    Views
    2,013

    Thanks Paolo for your contribution! So basically...

    Thanks Paolo for your contribution! So basically consistency is the key. Consistent strokes, consistently spaced apart. By eliminating variables the flatness will eventually come in. I've got a...
  5. Replies
    14
    Views
    2,013

    So I know this is my first go at scraping. I'm...

    So I know this is my first go at scraping. I'm as green as they come. Even the greatest started somewhere. I know I'm not winning any races but I guess its progressing? Thoughts? Does this look...
  6. Replies
    14
    Views
    2,013

    Well after some more passes here's where it's at....

    Well after some more passes here's where it's at. That end I was worried about still wouldn't come in so I threw a feeler guage under that end with it on the surface plate..... .0025. Yeah that end...
  7. Replies
    14
    Views
    2,013

    Scraping newbie help

    So this is my first attempt at scraping. I'm working on the gib to my new to me drill/mill. So far I've been in the initial stage of getting the hump out of the middle of it. I'm seeing spots from...
Results 1 to 7 of 7