Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: angelw

Search: Search took 0.01 seconds.

  1. Thread: Fanuc 6T Post

    by angelw
    Replies
    16
    Views
    1,277

    Hello Eric, That makes more sense. I suspect...

    Hello Eric,
    That makes more sense. I suspect that your control is quite an early build of the 6T Model A control. When in memory mode, do you see a whole page of code (when you have the program page...
  2. Thread: Fanuc 6T Post

    by angelw
    Replies
    16
    Views
    1,277

    Hello Eric, That's an unusual alarm number to be...

    Hello Eric,
    That's an unusual alarm number to be raised for an issue relating to the included angle of the thread form specified, because p/s060 is normally raised for the following reason:
    ...
  3. Thread: Fanuc 6T Post

    by angelw
    Replies
    16
    Views
    1,277

    Hello Eric, With regards to the threading cycle,...

    Hello Eric,
    With regards to the threading cycle, I assume G76, are you saying that the machine actually alarms when A58 is specified, or do you mean that the A58 is the error? It may be your...
  4. Thread: Fanuc 6T Post

    by angelw
    Replies
    16
    Views
    1,277

    Hello Brent, Type II was available with the 6T...

    Hello Brent,
    Type II was available with the 6T Model B.

    Regards,

    Bill
Results 1 to 4 of 4