Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Matt Rulla

Search: Search took 0.01 seconds.

  1. Replies
    14
    Views
    5,492

    I finished the Rucker 9-inch straightedge. I can...

    I finished the Rucker 9-inch straightedge.
    I can report that my casting machined flawlessly. No hard spots and zero inclusions or voids. I removed about 0.125" from the bottom and less than 0.100...
  2. Replies
    14
    Views
    5,492

    Keith allowed pre-orders starting back on Dec 1,...

    Keith allowed pre-orders starting back on Dec 1, 2019.
    Cost with shipping via USPS to me in Washington was $115.

    You can contact him through email: [email protected]

    Keith mentioned...
  3. Replies
    14
    Views
    5,492

    Even though the casting is only 9 inches long,...

    Even though the casting is only 9 inches long, it's just a little too big to fit on my Logan shaper (8" max stroke), so I'll rough it in on one of my mills. Before I start scraping, I'll try to post...
  4. Replies
    14
    Views
    5,492

    Keith is in production and shipping 9-inch...

    Keith is in production and shipping 9-inch camelback dove tail straight edges cast in grey iron from Windy Hill Foundry in Mississippi.

    I just received my raw casting today.

    274570

    274571
    ...
Results 1 to 4 of 4