Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: wd8rmo

Search: Search took 0.00 seconds.

  1. Replies
    16
    Views
    1,162

    I'm leaving two glue stops, one on each opposing...

    I'm leaving two glue stops, one on each opposing ends of the OD.

    I run this machine, for the most part. 24 hrs. for 6 days a week.

    In addition to checking on another machine, this concentricity...
  2. Replies
    16
    Views
    1,162

    Marcus, I feel very confident that you and I...

    Marcus,

    I feel very confident that you and I are on the same page of looking for the issue. I'm checking the part on a Makino 56i and spinning a .0001" indicator around it. Picking up the center...
  3. Replies
    16
    Views
    1,162

    Hello to all, and Marcus Thanks for the...

    Hello to all, and Marcus

    Thanks for the responses, Wire alignment is always done before this part is started (didn't think to add that).

    I run these machines (Mitsubishi FA20S) in an...
  4. Replies
    16
    Views
    1,162

    Wire EDM Concentricity

    Hello,

    I'm running a Mitsubishi FA20S. My issue is being able to hold a .0005" tolerance in the concentricity of the part.

    My material is very stable (DC-53 with 3 draws). I'm cutting a gear...
  5. Replies
    2
    Views
    428

    FA20S crash detection

    I'm running a FA20S wire EDM and would like to know if there is a parameter setting or a switch that will help detect power changes or crash detection. A few times the material becomes an obstacle...
Results 1 to 5 of 5