Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Engmaxx

Search: Search took 0.00 seconds.

  1. Replies
    32
    Views
    4,612

    Thank you Rob! :bowdown:I briefly looked and...

    Thank you Rob! :bowdown:I briefly looked and didn't find anything. I am attaching a pic of it below. These are nice but I would still need an out-rigger either to the front or the side OR I make a...
  2. Replies
    32
    Views
    4,612

    If I understand how they work correctly, the...

    If I understand how they work correctly, the orange pad raises when the stud is turned. Correct?
  3. Replies
    32
    Views
    4,612

    I am very leary of using the anchor bolt holes as...

    I am very leary of using the anchor bolt holes as a support point. From every manual I have read, they are only shown as anchor holes which means you are not supporting the weight of the machine...
  4. Replies
    32
    Views
    4,612

    :Ithankyou: Absolutely! Though moldcore does...

    :Ithankyou: Absolutely! Though moldcore does give me food for thought too. If I use leveling feet to some degree, I don't want to out-rig them especially on the front where they will (likely but...
  5. Replies
    32
    Views
    4,612

    I still need to measure the drop but you may very...

    I still need to measure the drop but you may very well be right on the stilts effect!!
  6. Replies
    32
    Views
    4,612

    I have seen some Bridgeports with leveling feet. ...

    I have seen some Bridgeports with leveling feet. Is this an acceptable solution?
  7. Replies
    32
    Views
    4,612

    Bridgeport Mill: How to set on unlevel floor

    Hello Again. I finally found the time to rearrange my garage and make the necessary changes to move the mill to its final working spot. I will soon be building an enclosed room around it and my...
Results 1 to 7 of 7