Search:

thanks for venting the ideas!

but back on topic again..

still one question, if the internal splines are nominal, why does the Form Diameter and Major Diameter Internal "Dri" talks against each...

I dont know if they changed over the years. But it should be made acording to ANSI 1972.

Customer job, I dont have the male part. I just need to make sure my internal will fit correcly :)

I did a test, make one internal and one external spline in mastercam gearhook. And this is the result (see picture).

From this I think the most accurate way would be to make the spline as a...

Hi,

Thanks, thats actually smart. But... will that really be correct? It feels like the Minor and major dimentions are going to be too small if I do it like that.

Why not making it as a...

Hi,


I'm using mastercam gear hook to make the spline drawing. 15 teeth and the pitch diameter are 23.8125mm so 0.002 clearance then. But how do I add it to the contour correcly.

15 teeth...

Hi,

I have been looking at Involute Spline ANSI B92.1 Involute Spline ANSI B92.1 Equations and Design | Engineers Edge | www.engineersedge.com

I need to make a drawing to edm a internal spline...