Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: kvarnis1

Search: Search took 0.00 seconds.

  1. Replies
    19
    Views
    8,908

    Piet, 950 kg is better than 500 kg and is no...

    Piet,
    950 kg is better than 500 kg and is no problem, my last lathe was 3400 kg... :D
    My van can handle 1400 kg and my shop is at ground level. But do I really need another lathe... ...
  2. Replies
    19
    Views
    8,908

    Oliver, thanks for the information. The owner...

    Oliver,
    thanks for the information. The owner said the spindle speeds were 750-1000-1500 rpm. Is that correct? Do you have any more techincal data or manual?

    Regards,
    Ola
  3. Replies
    19
    Views
    8,908

    Piet, I have just spoked to the owner. The two...

    Piet,
    I have just spoked to the owner. The two levers at the lower RH side is for speed selection on the three-speed motor and start/stop for cooling pump. The lever higher up is for forward/reverse...
  4. Replies
    19
    Views
    8,908

    Have anyone heard of Magdeburg Lathes? ...

    Have anyone heard of Magdeburg Lathes? :confused: I only found one picture on the net of this type. It has about 80-90 mm center height and 500-600 mm between center. It has both longitudal and...
Results 1 to 4 of 4