Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Mike1974

Search: Search took 0.02 seconds.

  1. Replies
    9
    Views
    755

    Not sure I follow? Are you talking about this...

    Not sure I follow? Are you talking about this page?

    311572

    Normally I don't have to mess around, I just change (when needed) top to 1, etc. Most of the time I let the setup guys do find and...
  2. Replies
    9
    Views
    755

    That's the thing, everything was set to -1,...

    That's the thing, everything was set to -1, posted as G55. Set top to 0 and op2 to 1 and posted everything as G54?? :confused:
  3. Replies
    9
    Views
    755

    No I don't think so. Never had a problem in the...

    No I don't think so. Never had a problem in the past with work offsets. I did figure out my X problem (at least I'm not going nuts LoL). Had my datum at the fixture instead of part... :leaving:
    ...
  4. Replies
    9
    Views
    755

    OLD Mastercam x6 issues

    So this probably won't get many responses as this software version is pretty old.

    Posted a program yesterday Op1 and Op2, both set to work offset -1 (first available), posted both out as G55...?...
Results 1 to 4 of 4