Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: artelogic

Search: Search took 0.00 seconds.

  1. Replies
    26
    Views
    1,921

    Will check that tomorrow. But I assume, the...

    Will check that tomorrow. But I assume, the answer to my question is "yes it's normal, because the CPU is to slow".

    And yes, Gs are not modal. Omitted G is interpreted as G01.
  2. Replies
    26
    Views
    1,921

    Yes, it is to chamfer are 3D-Spline. But it is...

    Yes, it is to chamfer are 3D-Spline. But it is not the complete code, it's even longer.
    332927

    But the the G64 does something. If I use G60 instead with a simpler geometry, it pauses after each...
  3. Replies
    26
    Views
    1,921

    N10 G53 N12 G90 N14 G64 N16 M62 N18 G17 N20...

    N10 G53
    N12 G90
    N14 G64
    N16 M62
    N18 G17
    N20 M9 M5
    N22 T1
    N24 S+800 F80
    N26 G0 X-1.643 Y-5.461 Z5
    N28 G0 Z1.125
  4. Replies
    26
    Views
    1,921

    Deckel FP2NC Dialog4 Helix

    My FP2NC shortly pauses after each G2/3 with X,Y,Z as it was in G60-Mode, although it is in G64-Mode. Is that normal?
    G2/3 with X&Y only it runs smooth as expected.
Results 1 to 4 of 4