Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: EmanuelGoldstein

Search: Search took 0.02 seconds.

  1. Replies
    50
    Views
    3,030

    You might want to be careful there, triumph. Some...

    You might want to be careful there, triumph. Some of us have been around a while .... the les said, the better, maybe :D

    Since I'm here ... pavt ? you're full of poop. 'nuff said.
  2. Replies
    50
    Views
    3,030

    You've got some verniers and a protractor ? Cool...

    You've got some verniers and a protractor ? Cool :D
  3. Replies
    50
    Views
    3,030

    By Jove, he's gottit ! I never think of that cuz...

    By Jove, he's gottit ! I never think of that cuz I never had one but that's the best plan yet. Mud's got his head on straight :)
  4. Replies
    50
    Views
    3,030

    Unless the teeth are bad on the other side of...

    Unless the teeth are bad on the other side of that photo, you're crazy to even consider cutting new teeth. Cut off the small diameter part of the shaft, make a new one, bore out the old gear and...
  5. Replies
    50
    Views
    3,030

    There's a basic problem with that ... there's no...

    There's a basic problem with that ... there's no "always" with gears :)

    Generally helicals are defined in the normal plane, yes, because the cutters you buy off the shelf are made that way. But...
  6. Replies
    50
    Views
    3,030

    Really ? From what point ? Out by the tips, in...

    Really ? From what point ? Out by the tips, in the root, at the pitch diameter ? How are you going to know where the pitch diameter is ? The helix angle depends on where you measure it and gears...
  7. Replies
    50
    Views
    3,030

    All this talk about "standards" .... with gears,...

    All this talk about "standards" .... with gears, these numbers only apply to 'standard' teeth on 'standard' center distances. If you take a pair of 8 pitch 14.5* pa gears and spread the center...
Results 1 to 7 of 7