Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: AD Design

Search: Search took 0.01 seconds.

  1. Replies
    45
    Views
    5,441

    First off Iíll have to state that Iíve never made...

    First off Iíll have to state that Iíve never made a knife, or anything else, from M390. My reading up on it tell to be an excellent material, but my experience with the properties are zero so use...
  2. Replies
    45
    Views
    5,441

    There's even a point in the overheat cycle where...

    There's even a point in the overheat cycle where the material starts raising up into the wheel through thermal expansion, warping, or both. The pass starts ok but rapidly gets worse as you travel. It...
  3. Replies
    45
    Views
    5,441

    -While it may be "possible" it's not good advice...

    -While it may be "possible" it's not good advice to give someone new to grinding. My advice was "not to trust it". That you have avoided disaster should not serve to encourage others to attempt...
  4. Replies
    45
    Views
    5,441

    I'm not the last word in grinding but I'll try to...

    I'm not the last word in grinding but I'll try to offer something useful. First off what material are you grinding? I'll presume that you're making knives and using the most common materials. Is your...
Results 1 to 4 of 4