Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: 99Panhard

Search: Search took 0.01 seconds.

  1. Replies
    50
    Views
    3,073

    Thanks for the link. I don't doubt they could do...

    Thanks for the link. I don't doubt they could do the job and I will send it to the owner of the car although I know how he will react. If he doesn't already know them he'll want to send them a few...
  2. Replies
    50
    Views
    3,073

    Some better pictures. 297985[/ATTACH ...

    Some better pictures.

    297985[/ATTACH

    [ATTACH=CONFIG]297986
  3. Replies
    50
    Views
    3,073

    The gear and the shaft were made in one piece....

    The gear and the shaft were made in one piece. The hex that shows in the picture is a screw-in piece that was used to adjust end play in the shaft. The White company only built about 137 of these...
  4. Replies
    50
    Views
    3,073

    As to it being an odd pressure angle. While I've...

    As to it being an odd pressure angle. While I've no proof, that is very unlikely. White was a charter member of the ALAM (the Association of Licensed Automobile Manufacturers). When the Selden...
  5. Replies
    50
    Views
    3,073

    [QUOTE=Jim Christie;3612185]If you have or can...

    [QUOTE=Jim Christie;3612185]If you have or can get the use of a gear pitch gauge similar to the one shown here ,
    ...
  6. Replies
    50
    Views
    3,073

    Not with this car, and certainly not with this...

    Not with this car, and certainly not with this owner... He's one of the top people in the country for sorting out expensive pre-war cars and making sure they are as good, or better than they were...
  7. Replies
    50
    Views
    3,073

    Thanks again John, I'm going to print this out as...

    Thanks again John, I'm going to print this out as it's very useful.

    jp
  8. Replies
    50
    Views
    3,073

    I know. I've never done a helical before but you...

    I know. I've never done a helical before but you have to start somewhere. I remember you telling me the OD could be larger for a helical gear which is why I wasn't concerned. Thanks for putting my...
  9. Replies
    50
    Views
    3,073

    A Gear Pressure Angle Question

    I'm helping a friend with his 16-valve 1917 White touring car. The one part that is damaged is the water pump shaft, not from wear but from galvanic corrosion. It's an interesting challenge and is...
Results 1 to 9 of 9