Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: camscan

Search: Search took 0.01 seconds.

  1. Replies
    45
    Views
    2,608

    [email protected] Go for it, I'm going to...

    [email protected]
    Go for it, I'm going to enjoy this,I hope you do.
    Give me your two top speeds or serial no. I need to know your machine.
  2. Replies
    45
    Views
    2,608

    Do not ever use indexing time out of the book. On...

    Do not ever use indexing time out of the book. On a fast cycle go for an extra 50%.But whatever the cycle time always increase it.
    Think about this,on your OOG the index time is 1/4 second. All...
  3. Replies
    45
    Views
    2,608

    Can you design your own cams? If you need any...

    Can you design your own cams? If you need any help just shout, you won't be the first
  4. Replies
    45
    Views
    2,608

    Really great when people come back with news,...

    Really great when people come back with news, good or bad.
  5. Replies
    45
    Views
    2,608

    Do you do any 2 op on your B&S? Get it right and...

    Do you do any 2 op on your B&S? Get it right and walk away.
    Perhaps you should get that pick up unit before somebody beats you to it.
  6. Replies
    45
    Views
    2,608

    When/if you do try it try reversing the saw,it...

    When/if you do try it try reversing the saw,it won't cut, which is good, but it does knock the tit off. I don't mean reversing the motor,just turn the saw over.
  7. Replies
    45
    Views
    2,608

    Can you not pick up and de-burr, with a slitting...

    Can you not pick up and de-burr, with a slitting saw? I have do e this successfully.
  8. Replies
    45
    Views
    2,608

    I assume that you used the same cam. If so I...

    I assume that you used the same cam. If so I would stay with that cam,a day with no problems is the only way to fly. Cycle time is never important,what is in the bucket at the end of the day is...
  9. Replies
    45
    Views
    2,608

    Use the same set up and give it a go. Form...

    Use the same set up and give it a go. Form threading is usually done at higher revs but if you are sure that the cut tap was not crowding on the way in or out then you should be fine.
Results 1 to 9 of 9