Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: pecosbill

Search: Search took 0.00 seconds.

  1. Replies
    26
    Views
    1,518

    I pulled the AC motor to address the bearings,...

    I pulled the AC motor to address the bearings, commutator, brushes, etc. I was surprised to see the motor plate says it is 50 Hz. I removed a grease fitting and hit it with the grease gun to push...
  2. Replies
    26
    Views
    1,518

    That sounds like a good thing to do. Is spindle...

    That sounds like a good thing to do. Is spindle reassembly pretty straightforward, or is it a critical and complicated setup process? I would think replacing the spindle bearings at this point...
  3. Replies
    26
    Views
    1,518

    Thanks, this will be helpful.

    Thanks, this will be helpful.
  4. Replies
    26
    Views
    1,518

    It looks like the peeling paint is from age,...

    It looks like the peeling paint is from age, seasonal thermal excursions in a garage, poor adhesion, etc, and not pressure washing. There is some surface rust from humidity and condensation but it...
  5. Replies
    26
    Views
    1,518

    Good point on the bearings, I'll have to check...

    Good point on the bearings, I'll have to check them. I suppose that means motor bearings too. :(
    Thanks.
  6. Replies
    26
    Views
    1,518

    Attaching more pics.311144311145311146311147

    Attaching more pics.311144311145311146311147
  7. Replies
    26
    Views
    1,518

    I am about a half hour north of Indy. Thanks for...

    I am about a half hour north of Indy. Thanks for the input.
  8. Replies
    26
    Views
    1,518

    Starting up an old EE

    I have a Monarch 10EE that has not been run in at least 30 years. It has been in the family that long, stored in a garage. I believe it was taken out of service just before the family acquired it. ...
Results 1 to 8 of 8