Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: crasher455

Search: Search took 0.00 seconds.

  1. Replies
    11
    Views
    9,145

    The plates are 1" thick. And the part is a disk...

    The plates are 1" thick. And the part is a disk 8" outside diameter with teeth on it like a saw blade. The outside is water jet cut and there will be a 1/8" hole 1/4" off the inside edge of the bore...
  2. Replies
    11
    Views
    9,145

    wire edm speed through thick material.

    This may have been covered here somewhere before but here is my question.
    Just for some background I have never run or setup an EDM

    I have a job were I need to cut a 3" diameter hole with 6...
Results 1 to 2 of 2