Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: EDMgineer

Search: Search took 0.00 seconds.

  1. This is a highly underrated post, my good sir....

    This is a highly underrated post, my good sir. Those hoping to move beyond typical die shop EDM work should be saving this for future reference. Wait... is HAZ really a thing with water jet?

    I...
  2. Replies
    18
    Views
    3,073

    Late to the party, but have you found the source...

    Late to the party, but have you found the source of the issue? If not I would suggest roughing the OD feature first... That's where any potential movement is likely to happen.

    Also have you tried...
  3. Replies
    15
    Views
    5,742

    Either it's time to dig up the ol' manual and...

    Either it's time to dig up the ol' manual and find the list of tech settings to find the tension setting parameter or you'll be in luck and someone here who knows will be kind enough to help you out....
  4. Replies
    15
    Views
    5,742

    First check to be sure your wire guides can...

    First check to be sure your wire guides can accommodate that much taper. Next make sure the flush nozzle isn't interfering with the wire when at that angle.

    After verifying those two things turn...
  5. Replies
    1
    Views
    1,730

    Not familiar with the Fanucs but I'm curious how...

    Not familiar with the Fanucs but I'm curious how extreme your taper angle is
  6. PM sent. Thanks for the response!

    PM sent. Thanks for the response!
  7. Need Charmilles board repair... Found an old post by a PM member who does this. Help?

    I hope this isn't violating posting rules...




    Can anyone help me with contact info for Mdynac? I see his last activity here was late May so I'm hoping to reach him regarding some board...
  8. Thread: Offset help!

    by EDMgineer
    Replies
    38
    Views
    5,503

    Perhaps I misunderstand, but I think you may have...

    Perhaps I misunderstand, but I think you may have quoted the wrong poster. Don't like to take credit where it's not due.

    Good to hear you came up with a solution. It'd be a good idea if/when you...
  9. Thread: Offset help!

    by EDMgineer
    Replies
    38
    Views
    5,503

    Our RoboFil 240CC's have three different power...

    Our RoboFil 240CC's have three different power settings for edge find. (0,1, & 2). The higher the # the more juice to the wire.

    For a ground surface that I want no visual mark from edgefind : 0...
  10. If an acid/CLR ultrasonic soak won't do it...

    If an acid/CLR ultrasonic soak won't do it blasting is probably your only option.

    Don't use sand! Use #10 or smaller glass bead at as low a pressure as possible while not holding the blast nozzle...
  11. Thread: Offset help!

    by EDMgineer
    Replies
    38
    Views
    5,503

    With the minimal information provided it looks...

    With the minimal information provided it looks like, as Bradracer pointed out, the part is likely a different size than the CAD data you're programming with. Resulting in your location being off when...
Results 1 to 11 of 11