Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Marco Schwan.

Search: Search took 0.00 seconds.

  1. Replies
    13
    Views
    1,740

    I really donít wanna make them adjustable since...

    I really donít wanna make them adjustable since the whole point of the fixed rollers is to be always perfectly 90degrees to the table.
    Iíve also seen this design commercially before so I know it...
  2. Replies
    13
    Views
    1,740

    Sanding Belt not tracking properly

    Heyho!

    (Click the link on the bottom for high-res pictures)

    I'm building an oscillating edge belt sander right now and I have some major problems getting the belt to track.

    Its a 3 roller...
  3. Replies
    7
    Views
    883

    I already have a pretty good Motor on my lathe -...

    I already have a pretty good Motor on my lathe - a 3-Phase Motor, forward and reverse, 2,2Kw @1480rpm.
    I got this Motor here dirt cheap (was going to be thrown awy, or rather salvaged next week)....
  4. Replies
    7
    Views
    883

    What Motor am I dealing with?

    Heyho!

    This seemed the best place in the forum to post this.

    I found a motor on eBay which I want to use with my lathe.
    Generally speaking itís a 3 Phase Motor und the ~4hp Range.
    The kicker:...
  5. 1928 "Ehrlich" Lathe - Spindle teardown (Help request)

    Heyho!

    I've recently posted about the restauration of my new(old) Ehrlich Lathe.
    The one thing I didn't dissasemble and clean was the spindle itself.

    I've done that now and it turns out its...
  6. Replies
    14
    Views
    1,430

    Hey, Thank you very very much for your...

    Hey,

    Thank you very very much for your detailed instructions!!

    From just reading it Iím guessing that my back bearing is set good, because itís getting slightly warm, but far from...
  7. Replies
    14
    Views
    1,430

    Here are some more pictures, inside stuff and the...

    Here are some more pictures, inside stuff and the bearings, well bushings.

    276079276080276081276082276083

    Here's an Imgur Link with high-res versions of the photos, including some more Photos:...
  8. Replies
    14
    Views
    1,430

    Thank you very much. Yes, the article you are...

    Thank you very much. Yes, the article you are referring to is just the one I found, and beeing pretty much the only thing I found.
  9. Replies
    14
    Views
    1,430

    Hmm yeah, I did notice that as soon as a little...

    Hmm yeah, I did notice that as soon as a little pressure was on them they would lock up really quickly. With preload I should have been more specific, I mean just enough so they arenít lose and...
  10. Replies
    14
    Views
    1,430

    1928 "Ehrlich" Lathe

    Heyho!

    I've been meaning to get a metal Lathe for a few years now; but it was always low on the priority list.
    But I do keep looking at e.g. ebay from time to time for new offers.
    This one I...
Results 1 to 10 of 11