Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: VanCan

Search: Search took 0.00 seconds.

  1. Replies
    5
    Views
    1,028

    Pretty scary, I am betting the driver needed a...

    Pretty scary, I am betting the driver needed a hug after post woodpile.
  2. Replies
    15
    Views
    4,863

    I picked up a 10hp air compressor off them a...

    I picked up a 10hp air compressor off them a while back - they will bargain quite a bit on the prices I am betting. The prices are high, but you know what its like when someone drops the Monarch...
  3. Replies
    15
    Views
    4,863

    Just a heads up - a local place in British...

    Just a heads up - a local place in British Columbia (Canada) is selling off a few Monarch EE and some other very clean machine equipment (American Pacemaker etc.). With the way the Canadian dollar is...
  4. Replies
    5
    Views
    991

    I have a large Baldor grinder that isn't...

    I have a large Baldor grinder that isn't anchored, but the stand I made weighs probably 200 lbs and there is a sheet of 3/4" steel for the base (not big enough that I am standing on, but this is a...
  5. You can get anti-splatter spray from some welding...

    You can get anti-splatter spray from some welding supplies: might help you a bit but I would save the time/money by doing some practice welding prior to your finished unit to dial in the...
  6. Replies
    109
    Views
    6,325

    I'm lucky I live in an area where I can treat...

    I'm lucky I live in an area where I can treat them with A little vitamin "L": apparently they are very allergic.

    I have often thought about perhaps argon/propane put down into the hole to...
  7. Thread: lathe DRO Info

    by VanCan
    Replies
    8
    Views
    1,001

    I use this also, and the scales are by far my...

    I use this also, and the scales are by far my favorite I have used yet. Not cheap, but very reliable and well designed.
  8. Replies
    20
    Views
    4,420

    I witnessed the same type of abrasion for...

    I witnessed the same type of abrasion for molybdenum sulfide drying out on automatic greasing systems in a hydro electric power plant. If the feed of new moly got interrupted/stopped, the moly would...
  9. Replies
    13
    Views
    2,702

    This Stefan does a very good job of...

    This

    Stefan does a very good job of explaining making taper gibs. I might also reach out to Richard King for some of the finer points of scraping a gib to a proper profile - he had mentioned in a...
Results 1 to 9 of 9