Search:

or not:angry:
good luck

271431

if you can look at this and figure out what you have from the diagram on the valve you can probly get it out of McMaster carr forin one day

271432

all world in chicago Illinois has alot of parts and can cross the parker numbers

815-943-9111

that's a common directional valve with standard mount
from that number all world can probly match...

I have never heard of such a parameter
if you where desperate to stop the chuck movement you could pull the coil connector before turning on

search
mylar
at McMaster carr
I've used it with success for overlay repairs

I dont think this is the right page for what you are after
chuck open and close are going to be much lower than "xc"
from there it's been to long since I been in a t32 but it seems you toggle to an...

if you can get a generic set of parameters you should be able to get it going
you might have trouble with a couple options like tool eye or programmable tailstock but you can get by without that...

GTI spindle technology might have a shop in Michigan. I know they have ones in illinois

I've used them
run of the mill Bridgeport clone
parts available out of California
I'd buy one if price and condition is what I needed

with a two foot bar you can get "some" movement
cats right
you need to go in there and look around
could be nothing more than dirt floating around in there on that curveck could be a pinch couple...

Whittet-Higgins Company

these guys are pretty spectacular for locking devices

NSK makes all sorts of one off stuff for different mfgs.
the stuff on mazaks looks normal but is "special "
good luck
the are rebuilder/grinders out there

I drove one in the 70's
6k
best truck I ever drove

264516

hers one I've had in my watch for quite some time

ebay is full of them
I think you kinda want the 2 speed reversible to keep the low speed torque
not as many of them but still available for 700ish

sqt/ms are power house machines
the live tool knuckle in the turret is kinda of delicate and quite pricey
i maintained a 15ms for years and had great respect for machines capacity

first thought would be no unclamp confirmation getting to control

this behind a contactor is an easier circuit 263668

it's how all the machine builders do it now
gives you an easy way to kill a device for troubleshooting

yes you have a starter also
and you might need a 24 vdc supply to operate the thermal

sounds like improper installation of the option to me

there is a gap between tube and spindle i.d.
you can slow but sure pick the rusted fines out and save the whole thing
I've done it
it sucks

40 horse?
not sure his 15 hp rpc will pull that

" Not really in the same league."

neither is a mazak or a mori

his question was about a haas for a light duty cnc

I've had good luck with Haas
there phone support is generally solid
there repair parts cost less than Fanuc and Mitsubishi (mazak)
and there construction is often brilliantly simple.
they are NOT...

I've seen very nearly that
chips get packed in and then rust solid
no magic here, just pick and pound at it, I feel your pain brother