Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Azmotorhead

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    810

    WTB Kwik switch 200 holders

    I was fortunate enough to pick up a Bridgeport at auction last week.
    Unfortunately I didnt get any of the tooling that was set up for this machine. Mill has a Kwik switch II in it so I'm looking for...
  2. Replies
    3
    Views
    572

    Lazz, thanks for the response. I wouldn't mind...

    Lazz, thanks for the response.
    I wouldn't mind meeting up with you and discussing.
    Wed thru Thurs I'll be off work at 230. Off on Mon and Tuesdays everyweek
    I'm in Peoria
    Phil
  3. Replies
    3
    Views
    572

    Wtb axa qctp

    Just finished up the resto of a SB 9C looking to see
    if anyone has a good quality used AXA QCTP for sale.
    Did a search and look's like I just missed a few for sale.
    I'm a inexperienced novice...
  4. Replies
    2
    Views
    978

    Thanks Allen. Yes I'm just learning here

    Thanks Allen.
    Yes I'm just learning here
  5. Replies
    2
    Views
    978

    9c resto, scored shaft

    Finally got my 9c all apart and cleaned up ready to restore.
    Problem i see is the main shaft and corellating bearing surface are a bit scored.
    Should i just clean it up a bit and run it or should I...
  6. Replies
    1
    Views
    699

    Dis regard I found the info needed here after a...

    Dis regard I found the info needed here after a Google search.
    FOrum search didnt pull it up but a general search on google found it
  7. Replies
    1
    Views
    699

    Horizontal drive setup question

    Finally getting around to setting up a couple of SB 9's (A&C)
    I've looked through both books I have, How to run a lathe and the SB restoration book. Neither of them give a dimension for where to...
  8. Sent you a email about the Lathe

    Sent you a email about the Lathe
  9. Replies
    6
    Views
    1,489

    Thank you all. I'm sure I'll spend more time on...

    Thank you all.
    I'm sure I'll spend more time on on this site, but now I've got to get some work done
  10. Replies
    6
    Views
    1,489

    Mounting a 9A to table

    Hello all.
    I'm finally getting around to setting up a SB 9A. lathe hasnt been used for quite some time and it was given to me in boxes.
    I picked up a butcher block countertop for a table top to...
  11. Replies
    16
    Views
    2,326

    Gnead That is a awesome workbench. Can you give...

    Gnead That is a awesome workbench. Can you give me the overall dimensions of it please?
    Do you have a material list?
    Mind if I copy your design & build my own?
    Thanks
Results 1 to 11 of 11