Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: CRJarvis

Search: Search took 0.00 seconds.

  1. it was a job to do with out taking off the table.

    it was a job to do with out taking off the table.
  2. 329353 busted it had not used it in a wile and...

    329353 busted it had not used it in a wile and after a few passes it went. so stopped by a few bearing places in town and found this. 329354the PowerGrip 450H100 was just right. cut it and a hell of...
  3. just busted the belt on it last night anyone have...

    just busted the belt on it last night anyone have ideas on how to install it. i looking at trying not to take it all apart to do it.
    picked up a belt that will work will post info and photos as i...
  4. thanks for this wmsopko.com info it has helped me...

    thanks for this wmsopko.com info it has helped me out, thank you thank you. tried to reply to this before but have to wait for admin to approve.
  5. thank you. i have been reading everything i can...

    thank you. i have been reading everything i can to old manuals and lots of videos. this will help a lot http://www.wmsopko.com/sopko_04_to_30_53.htm Thank you.
    have been working on getting the Hub...
  6. has anyone seen anything like this for a Surface...

    has anyone seen anything like this for a Surface Grinder?
    https://oneway.ca/pdf/Balance%20Kit%20Vers%205.1%20Dec%202010.pdf

    https://www.youtube.com/watch?v=8PkMTcKt5s4
  7. Wheel adapters/ HUB for Covel surface grinder 10-1238

    My hub has a lot of ware on it and looking for a new one with the balencing hub.
    it has a 1-1/4" Arbor LH thread. looks like it can take up to a 3/4" thick Stone type 1,
    the old Hub i have does...
Results 1 to 7 of 7