Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Street

Search: Search took 0.00 seconds.

  1. Replies
    31
    Views
    3,370

    I must have been a bit late the powder i used...

    I must have been a bit late the powder i used came in tins... in 303 i was using AR2208 ( mulwex) with 42.5 gr in powder, cannot recall bullet gr but may have been 150gr so don't load off this look...
  2. Replies
    31
    Views
    3,370

    Its been a long time but i think the supplier was...

    Its been a long time but i think the supplier was RWS for the primers.
    If the alum dowel is a very close fit to the neck and the case full of water,( in the FL die) just put a rag around the dowel...
  3. Replies
    31
    Views
    3,370

    i used to put them in a full sizing die, then...

    i used to put them in a full sizing die, then fill with water and drive a alum rod down the neck of the case ( the rod was a close fit to the case in the die) they pop out rather easy.

    you need to...
Results 1 to 3 of 3