Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: jr2766

Search: Search took 0.00 seconds.

  1. Mazak QT-8 T2 Parameters - Assistance woydl be very much appreciated

    Firstly I have posted previously and received some replies for which I'm grateful but I am still in need of the full set of parameters for this machine and some advice as to how to enter them.ie.,...
  2. Replies
    2
    Views
    461

    Mazak QT-8 T2 Parameters help!!

    I have no doubt that this post will amuse many readers wondering why a old man would endeavor to get a CNC machine running. It might raise the frustration levels but it will be good mental exercise...
  3. Replies
    9
    Views
    3,607

    I have recently acquired a QT8 which had not run...

    I have recently acquired a QT8 which had not run for some time and the batteries were flat and all parameters have been lost.
    By chance would you have the pages for parameters (some of which I...
  4. Replies
    25
    Views
    6,486

    Broken Screw or tap extraction

    If it is possible to submerge the part I'd suggest you consider dissolving the tap using Alum. I've attached a link to a You Tube video which will amaze you. Chemical Removal of a Broken Drill Bit...
  5. Replies
    5
    Views
    1,784

    Tree Boring Head

    I have recently been given a Tree Boring Head which is capable of boring tapered holes - a real piece of engineering heritage.
    This is a superbly crafted piece which unfortunately has been made...
  6. Replies
    9
    Views
    6,343

    Different machine but very helpful Thanks for...

    Different machine but very helpful
    Thanks for taking the time to reply.
    Cheers
    Jim
  7. Replies
    9
    Views
    6,343

    Hi Stuart Many thanks for replying My issue is...

    Hi Stuart
    Many thanks for replying
    My issue is that the machine is only fitted with a cup wheel and I am assuming that if one wants to sharpen both flutes and the end cutting edges the air spindle...
  8. Replies
    9
    Views
    6,343

    Many thanks. I have one offer of a manual...

    Many thanks.
    I have one offer of a manual however appreciate you taking the time to reply.
    Jim
  9. Replies
    9
    Views
    6,343

    Cuttermaster Operators Manual

    Mike
    Many thanks for the offer.
    My email address is <[email protected]>
    Cheers
    Jim
  10. Replies
    9
    Views
    6,343

    Cuttermaster End Mill Sharpener.

    I have recently purchased a very nice Cuttermaster machine with the air spindle and it is currently fitted with a white cup wheel. Unfortunately the owners manual is not with the unit and I was...
  11. Replies
    4
    Views
    1,837

    Hi Ray Thanks for taking th etime ot reply. I'm...

    Hi Ray
    Thanks for taking th etime ot reply. I'm going Cuttermaster.
    Cheers
    Jim
  12. Replies
    4
    Views
    1,837

    Many thanks for taking the time ot reply. I'm...

    Many thanks for taking the time ot reply.
    I'm going the Cuttermaster Route
    Jim
  13. Replies
    4
    Views
    1,837

    End Mill Sharpeners

    I am considering the purchase of either a Cuttermaster CM 1 or a Darex E90 end mill sharpener.
    I have been unable to obtain any comparative information here in Perth Australia so I'd greatly...
Results 1 to 13 of 13