Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: eaw99517

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    1,095

    The arm itself seems to be fine. Well as far as...

    The arm itself seems to be fine. Well as far as I can tell.....it seems to be fine. All I am doing is switching the tool holders on the end of the tool changer arm from BT40 to CAT40. It was...
  2. Replies
    4
    Views
    1,095

    Yes I thought about adjusting the tool changer...

    Yes I thought about adjusting the tool changer arm. Unfortunately, in order to get the arm re-positioned after you loosen the bolts so that the CAT40 tool is accurately centered in the spindle bore...
  3. Replies
    4
    Views
    1,095

    MV-40 Z axis adjustment

    Hello, we have a new to us used MV-40 with a Yasnac MX3 controller that was recently purchased. It was originally set up with BT-40 tooling. The shop is set up for CAT40 tooling. We purchased new...
  4. Replies
    0
    Views
    1,468

    Strange problem with Mori Seiki MV40

    We have a Mori Seiki MV40 that was purchased used a few years ago and it has been sitting for some time. It has a Yasnac MX-3 controller. We just started using it with some regularity about a year...
  5. Not sure if this will help but we have an old...

    Not sure if this will help but we have an old Mori Seki MV-40 with a YASNAC controller hooked up to a desktop with about 50FT of cable. Had to reduce the baud rate to 2400 to get it to communicate...
Results 1 to 5 of 5