Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Richard King

Search: Search took 0.02 seconds.

  1. Henrick over in Norway sent me this about...

    Henrick over in Norway sent me this about Peening...file:///C:/Users/richa/Downloads/MIC_Green_Book_9th_Edition.pdf
  2. I was looking for a few emails I got from Archie...

    I was looking for a few emails I got from Archie and I got one he wrote to me from PA before he moved to CA.

    I did find this longggggg thread about how he rebuilt a Lucas for Tuckahoe Museum. I...
  3. Last time I heard when he retired from I think it...

    Last time I heard when he retired from I think it was Penn State or some school out there., he moved to Southern CA. I have not heard from him in a few years. I did invite him meet the rebuilding...
  4. I asked the professor the same thing and he said...

    I asked the professor the same thing and he said people should use long T-nuts. I have seen longer aprox 3" T-nuts. I was taught when I was an Apprentice to move the vise to the sides and not always...
  5. The table does not sag from overhang as I...

    The table does not sag from overhang as I originally thought too. Then I talked to the Engineering professor Archie C. who said a friend had done a paper on it in university and discovered it was...
  6. I heard back from redacted in Norway and he...

    I heard back from redacted in Norway and he attached a photo.
    He wrote Lex and copied me:

    Hi Lex,

    I've CC Richard in case the picture is of use to him when helping others.

    no problem. Ask...
  7. I heard back he said he stopped writing on the...

    I heard back he said he stopped writing on the forums and has been rebuilding a lot of machines. Here is what he said in his letter

    "Yes thats is all correct

    The process of peening worked...
  8. I had a student bring a Bridgeport table to a...

    I had a student bring a Bridgeport table to a class that was tested on 3 points at 30% and the table was off bent .012". We took the table down and layed it on the concrete slab outside the shop on...
  9. Here is a great post done by Engineering...

    Here is a great post done by Engineering Professor Archie Cheda who taught me how overtightening the Tee slots will peen or bend the tables/

    Lucas Horizontal Boring Mill going to Tuckahoe . . .
  10. We have been talking about this for years on...

    We have been talking about this for years on here. It works as Glen writes about it in the following old post. I use a cold roll 1" rounded end shaft about 6" long and use a 5 pound sledge. Hammer...
Results 1 to 10 of 10