Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Dualkit

Search: Search took 0.03 seconds.

  1. Replies
    19
    Views
    1,238

    M2 won't work, I have to use M99, M2 gets a...

    M2 won't work, I have to use M99, M2 gets a program to rewind, but it stops and won't repeat. M99 will rewind & repeat. Will try again tomorrow, using M99 in place of M2.
  2. Replies
    19
    Views
    1,238

    It won't work, it is either in the controller or...

    It won't work, it is either in the controller or the DNC software I use to send and receive, I just tried it. Everything goes in except when it hits N1, (I even tried N2) it thinks it has seen...
  3. Replies
    19
    Views
    1,238

    Thanks! I will probably give that a try later on...

    Thanks! I will probably give that a try later on today or tomorrow, got another puller job to set up.
  4. Replies
    19
    Views
    1,238

    Interesting, I only use #5XX variables for tool...

    Interesting, I only use #5XX variables for tool widths, part lengths, tool nose radii and the assorted calculations. Care to show an example of how to use as a counter? That is if it isn't a lot of...
  5. Replies
    19
    Views
    1,238

    M25 on my machine is for a door switch option,...

    M25 on my machine is for a door switch option, that I do not have. I think M25 on your machine is like M12 on mine. It just strangely stop working out of the blue. Mine will count on M2 and M30 on...
  6. Replies
    19
    Views
    1,238

    Thanks, I will try the stuff in the other thread...

    Thanks, I will try the stuff in the other thread tomorrow. Wasn't much of a wild goose chase, only took a couple minutes. I think my OT is revision C and it is almost 30 years old.
  7. Replies
    19
    Views
    1,238

    It takes M12 on mdi, but that does not alter the...

    It takes M12 on mdi, but that does not alter the count. The machine does not show a parameter 6710, in fact it has parameters 0-999 and some in the 8000's and that is it. It is only 2 axis, single 12...
  8. Replies
    19
    Views
    1,238

    I will check that out later tonight, the job is...

    I will check that out later tonight, the job is almost done. With my low budget homemade puller, no way I can let it run out of stock without me there. Been using the stop watch on my phone to make...
  9. Replies
    19
    Views
    1,238

    Fanuc OT stopped counting with count code.

    Here is a stumper, the lathe counts when using M2(end of program, reset) when doing single cycle parts. It will no longer count when putting M99(end of sub program)at the bottom preceded by M12 (end...
Results 1 to 9 of 9