Search:

Unfortunately Dale passed away a few years ago.

Gene,

What is the the issue with the machine?

If you don't wish to unsolder the real time clock battery,
you could always purchase a used motherboard on EBAY that
would work. Just may have to do a few things to make it
work. email me at...

Is this a mondo star with a rtc battery
on the motherboard? if so, you will either
have to unsolder this and replace or replace
the motherboard. The Cmos settings are probably
reset back to...

So, being a former Agie employee, I can tell you that
the detailed schematics for the DTR-50 are only held
by a few and are held like state secrets. However,
send me an email and I will respond...

peak current should be 64 average amps 50 or 60
aco bitmask 63

David,

Have you changed Q value in technology
from before?

Jim

It sounds as though you know where to set these options, but
I will assume that you don't. When the machine is booting and
is on the windows start page you must drag the cursor off the
bottom of...

David,

have to check the schematics. will get back to you

Jim

I could help you with some training over the phone
if you like. Was formerly with Agie and worked with
Rich back in the mid 90's. You can email me at
[email protected]

The video card can be plugged into any of the PCI slots(smaller buss).
Also this machine appears to be a Mondo Star. Does it have a mouse and
mouse tray on the front of the machine? If so, it is a...

the aluminum flex hose just directs the dielectric back into the reservoir.
The positioning of it is not critical.

david,

I believe the valve yv22 is staying open when it should
be closed. the line marked 220a is flushing pressure going
to the lower head that yv22 controls. the valve may need
replacement.
...

First of all, did you tap the internal tranformers for 480v?
there are two tranformers. Secondly does this machine have a
hand pendant? If yes, then make sure the estop on the hand
pendant is not...

Sorry, also you must have certain correction catalogs
to run. for instance, 1000-0 piece.

I am familiar with the machine. Need to see the
program and what is loaded into memory. you must
have technology loaded first, then 3000, 3111,3222,
3333, 3444 and then your program.

How are you holding the workpiece? A magnetic chuck holding
the work can create havoc.

If you are using an M98 with Q then you should be using a G91(incremental)
Also on the Taper Page the mode should be 11 and you should not use a
G51/G52.
Also the correct syntax is G01 X.4635...

email me to discuss at [email protected]

You encountered the errors when loading which CD, OS2 or
Agievision? Unfortunately, I do not have a PEC10 or SBC P5200.

you have to be more specific when you say "VMI".
Pec05 board? SBC board?
Will it not boot?

If you are sure your computer power supply is ok and the monitor
is good, the computer should boot to bios. If not, the motherboard
is probably bad. Do all the lights on the hand pendant stay lit?...

is it a futura II or futura III?

Is it lower gap box? If yes I can help.
[email protected]

The E5 alarm is caused by one of two issues: 1) Bad generator board. The GPM-50 board is in the lower rack of
boards to the left of the SBC-02 board. This board should have three large LED's lit...