Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: crzypete

Search: Search took 0.01 seconds.

  1. Oh and one last Picture- for Stephen and his...

    Oh and one last Picture- for Stephen and his "bad" influence on me. It's kinda too much knowledge somedays when you learn of a better way and have to do it that way because you just know it's better,...
  2. a few details of the door installed. You can see...

    a few details of the door installed. You can see the seal I went with and the rabbeted construction for the jambs.

    218473
    218474
    218475
  3. I Dug up some pictures of the last door I did. It...

    I Dug up some pictures of the last door I did. It was Sapele that I used a Timberstrand as a core for. By cutting 3/16" veneers on my bandsaw and sanding them down to 1/8 once they were adhered, I...
  4. I built my shop doors the same way as well, they...

    I built my shop doors the same way as well, they have been holding up well now ten years in.

    But these doors are entry doors to a nice house. Stephen, I remember reading your dovetail casing...
  5. Thanks for the replies. These are two standard...

    Thanks for the replies. These are two standard house entry doors. They will have some glass, possibly quite a bit of glass on one of them.

    Unfortunately, the ship has sailed on an air lock, this...
  6. Advice on building an exterior door for house in extreme cold environment

    I have a potential job building a pair or doors that will live in interior Alaska. Regular temps of up to -40ºF on one side of the door and standard house temps on the other. The Client has already...
Results 1 to 6 of 6