Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Morderesh

Search: Search took 0.00 seconds.

  1. Replies
    11
    Views
    1,123

    Hi, We don't have a track torch. The chamfers...

    Hi,

    We don't have a track torch. The chamfers don't need to be precise or have a high surfice finish, the biggest problem we have is it takes too long to do them by hand. We do have a 2 hand held...
  2. Replies
    11
    Views
    1,123

    What is the best way to cut chamfers

    Hello,

    I have a 30 mm thick steel plate that has 2 types of chamfers, 30 degree chamfer and two 45 degree chamfers. I was wondering what type of chamfer mill would you recommend for such a job?
    ...
  3. Old mill, no through spindle coolant, coolant not reaching inserts - U drill

    Hello,

    Using old Maho MH600E mill and trying to drill holes (22 mm diameter) into 20 mm steel (low carbon steel, S355 european) plate. Drilling with U drill that's meant to have through spindle...
  4. Replies
    5
    Views
    1,308

    Hey, Yeah, it was my fault. The tool wasn't...

    Hey,

    Yeah, it was my fault. The tool wasn't active when i did the zero point measuring. Now i go to MDI, activate the tool before i set zero point and it works.

    Thanks for replying.
  5. Replies
    5
    Views
    1,308

    Thanks for replying, I have tool lengths in...

    Thanks for replying,

    I have tool lengths in table so i'm good in that front, but cancelling out G52 is something i haven't tried. But if i restart the machine and then take zero point value, then...
  6. Replies
    5
    Views
    1,308

    Ok, i might be doing something wrong when i set...

    Ok, i might be doing something wrong when i set the G54 zero point value. Do i have to have certain tool active or some other G code active while setting G54 value?

    And tool changer shouldn't...
  7. Replies
    5
    Views
    1,308

    Maho MH 600 E - Z axis value

    Hello,

    Company got an old milling machine - Maho MH 600 E and we are trying to get it up and running.
    Everything works, did couple of test programs, but it seems that Z axis value changes between...
Results 1 to 7 of 7