Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Jhendrickson

Search: Search took 0.00 seconds.

  1. Hey Dmitry, The part numbers for the main...

    Hey Dmitry,

    The part numbers for the main spindle are as follows.

    Main Shaft
    1ea: M009-0016-81
    1ea: M009-0019-99
    1ea: M009-0016-80

    Counter Shaft
  2. Replies
    3
    Views
    1,194

    Hey Bob, I believe the alarm help message is...

    Hey Bob,

    I believe the alarm help message is referring to the 'check data' screen. On my OSP7000M, this screen can be accessed from the auto operation mode and then selecting check data (F7). I...
  3. Replies
    0
    Views
    617

    MAC Cooler Wiring

    Hey all,

    I have a new to me 2000 MX-45VAE it has a high speed spindle, osp7000m and chiller. The chiller came to me with no wiring hooked up from the machine. I'm looking for wiring for the wires...
  4. Replies
    8
    Views
    5,482

    Yeah I need to change the batteries, I saw the...

    Yeah I need to change the batteries, I saw the alarm, but the installation manual is vague about changing them. Is there a 'operators manual' that came with these machines? I received the NC and g...
  5. Replies
    8
    Views
    5,482

    That worked! I read about the RLSE and reset...

    That worked! I read about the RLSE and reset buttons but I didn't have the right process. Once I got the machine to a negative value I was able to get the machine to home itself. Thanks BROTHERFRANK....
  6. Replies
    8
    Views
    5,482

    I won the machine at auction in November of last...

    I won the machine at auction in November of last year. Didn't seem to be ran hard, it's got less than 1/2 the cycle time to power up time on it. It was filthy but is cleaning up nice.

    Sent from...
  7. Replies
    8
    Views
    5,482

    I just finished up cleaning the three limits on...

    I just finished up cleaning the three limits on the x axis. The ATC one was a little oily inside so I cleaned all three and checked continuity between the NO and NC contact and the switched seem to...
  8. Replies
    8
    Views
    5,482

    Brother TC32-A position error X

    Hello everyone. I recently acquired a tc32a and got around to powering it up and have run into a alarm 6321 *position error x* that i cant clear. When I first powered up the machine I had a x over...
Results 1 to 8 of 8