Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: RforEDM

Search: Search took 0.00 seconds.

  1. Replies
    10
    Views
    1,479

    Using the U/V alignment has worked really good...

    Using the U/V alignment has worked really good for me just make sure to center the bore before doing it and then recenter if it needs to be really accurately located. Done quite a few jobs where...
  2. If someone is actively at the machine while its...

    If someone is actively at the machine while its probing for the setup I just set a M00 and use the thread button there's no drain time for it.
  3. Replies
    432
    Views
    124,563

    I always hear: More than one way to skin a cat...

    I always hear:
    More than one way to skin a cat or the alternative more then one way to F*** a goat you just hold the head ill show ya
  4. - 0-6" set of mics - 1/100th scale - caliper -...

    - 0-6" set of mics
    - 1/100th scale
    - caliper
    - .00005/.0001/.0005 indicators with magnetic and non magnetic base
    - "a fine adjuster" as my gramps would say usually a piece of aluminum/brass/nylon...
  5. Replies
    9
    Views
    1,500

    It worked!!! :D All i needed to do was a full...

    It worked!!! :D

    All i needed to do was a full restart of the computer now its posts perfectly.

    Thank you immensely :D
  6. Replies
    9
    Views
    1,500

    I ran edmmachinssetup.exe but it doesn't seem to...

    I ran edmmachinssetup.exe but it doesn't seem to have fixed it now it wont post at all.
    I changed the max arc radius to 4.0 just to see it that worked to no avail.

    Could i have done something...
  7. Replies
    9
    Views
    1,500

    I've sent a few messages but its not showing them...

    I've sent a few messages but its not showing them as sent messages so please let me know if you've received them.
  8. Replies
    9
    Views
    1,500

    Ill try and email you a file. (have to bare with...

    Ill try and email you a file. (have to bare with me i new to the whole file sending thing on forums)

    Its a relatively simple form of three straight fingers positioned 120 degrees around a fixed Id...
  9. Replies
    9
    Views
    1,500

    Bobcad v23 Edm help

    V23 doesn't seem to want to post radius' (no i or j's) it just outputs straight cuts. Its the same post I've always used and until now I've never had the problem.I also only have one machine under...
  10. Replies
    3
    Views
    1,617

    Thank you both for the replies they were very...

    Thank you both for the replies they were very helpful Now i don't have to be so skiddish about a complete disassemble of the lower head for maintenance. :D

    I don't believe its ever been done...
  11. Replies
    3
    Views
    1,617

    Lower head alignment

    So im relatively new to the whole WEDM side of machining. Ive been able to stumble my way through quite a few things but this one i cant seem to find answer for.

    I run a sodick ag600l wedm and i...
  12. Replies
    3
    Views
    1,688

    I have this same on my sodick ag600l. I was told...

    I have this same on my sodick ag600l. I was told that the upper conductivity plate will have very little wear as opposed to the lower because as the wire gets used its becomes almost like a Saw blade...
Results 1 to 12 of 12