Search:
Type: Posts; User: Scott314
Search: Search took 0.00 seconds.
-
11-17-2020, 04:05 PM
- Replies
- 53
- Views
- 3,215
Lowering the feed is not entirely about low SFM,...
Lowering the feed is not entirely about low SFM, although I think that's a valid point as well. It's about not pinching the insert. This holds true even on parts with a thru hole, where your...
-
11-15-2020, 10:38 PM
- Replies
- 53
- Views
- 3,215
Seconding what Sol said, sure sounds like its...
Seconding what Sol said, sure sounds like its getting beat up as it approaches center. I would cut the feed by like 50% when getting towards the end of the cut. I'm not sure I would even bother with...