Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: RC99

Search: Search took 0.02 seconds.

  1. Replies
    104
    Views
    29,137

    Are they not able to be rewound? I had my 7EL...

    Are they not able to be rewound?

    I had my 7EL armature rewound and converted from 110V to 240V at the same time.
  2. Replies
    104
    Views
    29,137

    Being a bit damp today but only angel pee falling...

    Being a bit damp today but only angel pee falling I pulled apart my 8E to try to measure up the size of the helical gear on the end of the motor. Without much luck I might add. :D

    Anyway if anyone...
  3. Replies
    104
    Views
    29,137

    Getting it rewound should not be a problem, I had...

    Getting it rewound should not be a problem, I had the same motor rewound and changed from 110V to 240V without any dramas.

    I am being a bit slow here, but just realised Biax make a Black model...
  4. Replies
    104
    Views
    29,137

    I think that would be understandable if these...

    I think that would be understandable if these were a $300 power tool, but they are a $5000 power tool.
  5. Replies
    104
    Views
    29,137

    I knew there was a parts breakdown somewhere......

    I knew there was a parts breakdown somewhere... Found it

    http://www.practicalmachinist.com/vb/general/biax-8e-flaker-looking-instructions-263698/#post2018268
  6. Replies
    104
    Views
    29,137

    Interesting how many different models they made....

    Interesting how many different models they made.

    Here is a 10E. By the serial number I think a 1982 model as all those older ones the S/N always seems to end in a two digit number, either 6x, 7x...
  7. Replies
    104
    Views
    29,137

    There was never any need to Pete as 240V is still...

    There was never any need to Pete as 240V is still well within the voltage tolerance, which is 230V +10% -6%. I believe the influx of home solar systems injecting electricity into the power grid has...
  8. Replies
    104
    Views
    29,137

    The brush caps would not be hard to make, they...

    The brush caps would not be hard to make, they are only plastic.

    I have a couple of spares and measured up the thread.

    I suspect it is supposed to be 16mm X 1mm as the devices are european...
Results 1 to 8 of 8