Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Ifitsmetal

Search: Search took 0.00 seconds.

  1. And I never kissed my wife until we were married.

    And I never kissed my wife until we were married.
  2. Replies
    16
    Views
    1,246

    I tap 2" 11 1/2 pipe thread in my lathe. Stick...

    I tap 2" 11 1/2 pipe thread in my lathe. Stick the end of the tap in the bored tapered hole. Live center in the end. Crescent wrench on the flats on the tap with the wrench end on the cross slide on...
  3. Good eyes !!

    Good eyes !!
  4. show some pictures, inquiring minds want to know.

    show some pictures, inquiring minds want to know.
  5. See below.

    See below.
  6. You set your wanted size to zero on the indicator...

    You set your wanted size to zero on the indicator on the device with an outside mike. Then as you slide it into the bored hole, you read the dial as either plus or minus in the 10ths.. If you are...
  7. Thank you gentlemen !!!! Appreciate your...

    Thank you gentlemen !!!! Appreciate your knowledge... You know who you are..
  8. Did not know that I had to clean up the area to...

    Did not know that I had to clean up the area to take a photo nor get a decent response.
  9. Replies
    25
    Views
    2,175

    Miller welder

    Just sold a 450 amp, 100% Duty Cycle Mig for 500.00. It was 40 years old and would weld till you got tired of welding. Just saying
  10. Measuring device that I have used in the past on boring bar work, measures the bore

    with out removing the bar. This is the only one that I have ever seen. Made in Germany I believe. Anybody know the correct term/name of this device?267250THANKS !
Results 1 to 10 of 12