Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Froneck

Search: Search took 0.01 seconds.

  1. Replies
    8
    Views
    1,069

    Up-Date

    When I put the wheel on the plug a second time I made the plug slightly under size and mounted the wheel with Loctite. Wasn't yet cured due to Aluminum wheel. But I indicated the one side with the...
  2. Replies
    8
    Views
    1,069

    Threads are OK, hold nut as I spin the shaft...

    Threads are OK, hold nut as I spin the shaft (easy to do since there is another wheel on the other side), nut does not wobble. But possibly when tightening will shift.
  3. Replies
    8
    Views
    1,069

    The wheel seems fine. I made the plug and mounted...

    The wheel seems fine. I made the plug and mounted the wheel, no visible shimmy.
    Put an indicator on the aluminum, ran out about .003" So I bumped it until it run 0. Moved indicator near the center...
  4. Replies
    8
    Views
    1,069

    Intended to make a plug as suggested in the lathe...

    Intended to make a plug as suggested in the lathe and put the wheel on if to see where the problem is.
    If I do have to re-bore the mounting hole should I use cardboard(Cereal box type) shims? Being...
  5. Replies
    8
    Views
    1,069

    Diamond wheel mounting issue

    I purchased a 6" X .40 X 1.250 1A1 Resin Bonded wheel on ebay. Actual bore Dia. 1.253 and my Darex drill grinder spindle is .6238. Made a bushing to mount the wheel, Id and OD cut while chucked so no...
Results 1 to 5 of 5