Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: TCMACH3

Search: Search took 0.00 seconds.

  1. 250468250467. Here is a photo of it put back...

    250468250467. Here is a photo of it put back together & info on the seal that I put under the table it seems to have worked well.
  2. 250440250440

    250440250440
  3. I have a sight glass for the oil level that...

    I have a sight glass for the oil level that screws into the housing on mine.I used a oil & water resistant packing seal that was made of PTFE- impregnated synthetic fiber size 1/8” x 1/8” square and...
  4. I have got every piece of my rotary table...

    I have got every piece of my rotary table apart.The only thing left on the casting is the oil sight glass.Do you know if it is screwed in or pressed in?I want to take it off too.Im gonna fix...
  5. I greased all the bearings & shaft before...

    I greased all the bearings & shaft before reassembling on the worm assembly.After i get my table off & cleaned I probably will grease the bearings & use 90w gear oil in the housing when i get it all...
  6. I got my shaft assembly out,took all apart and...

    I got my shaft assembly out,took all apart and cleaned everything,put a new o- ring on it & put back together.I used fine sandpaper and sanded the outside & honed the bore on the housing.I put the...
  7. Thanks Jack that is great info.I assume the table...

    Thanks Jack that is great info.I assume the table should come off first right? Is the nut RH or LH? I think my clockhouse is stuck I can’t rotate it to disengage, probably from no oil.Any other...
  8. HI Jack thanks for the reply.I had a typo above.I...

    HI Jack thanks for the reply.I had a typo above.I have purchased a Royal/Zeatz PHVGI 320 made in Spain.It is horizontal & verticle 12”.The table is mark free great shape,no rust,locks & turns fine...
  9. Can you post the manual or any info on how to...

    Can you post the manual or any info on how to adjust the handle on the Zeatz pin 320?I can’t get the link to open. Thanks
Results 1 to 9 of 9