Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Dicks4fingers

Search: Search took 0.00 seconds.

  1. Broke of adjustment for tramming in head... now what. 4hp series 2 bridgeport

    it's the one in the head for the x axis. Do i gotta take the entire head off this thing now? Not a good day.
  2. Replies
    14
    Views
    1,012

    I don't know if high feed mills will help. My...

    I don't know if high feed mills will help. My biggest problem is clearing chips and I can't use through spindle coolant
  3. Replies
    14
    Views
    1,012

    the pockets are about 1.5 wide but have a lot of...

    the pockets are about 1.5 wide but have a lot of stuff in them so some parts are only about .7 or .6 wide
  4. Replies
    14
    Views
    1,012

    Nope. Closed pockets. Worst is almost 2 inches...

    Nope. Closed pockets. Worst is almost 2 inches deep and only .6 inches wide in some spots
  5. Replies
    3
    Views
    564

    well not one off it goes well. Been running...

    well not one off it goes well. Been running everything in 304
  6. Replies
    14
    Views
    1,012

    When to plunge rough?

    I'm trying to put 2 to 1 and even some .75 inch wide pockets into 304 stainless from about 1 inch to three inches deep. It's a bit of a pain and as someone who tries to throw hem style paths at...
  7. Replies
    3
    Views
    564

    chrome moly vs 304 stainless

    I've cut a bunch of 304 and am about to do a pretty small run of stuff in chrome moly. Is using my numbers from 304 going to give me a pretty conservative place to work from? I'm under the impression...
  8. Fixed it myself just found one of the pins fell...

    Fixed it myself just found one of the pins fell out. It was broke long ago it looks like and some one just slipped a loose fitting bolt in
  9. I think the special is only 2hp and this one is...

    I think the special is only 2hp and this one is 4. Yeah that's the name though
  10. Imgur: The magic of the Internet...

    Imgur: The magic of the Internet Pictures of the mill and power feed
  11. Power feed lost almost all torqe in x axis. Everything else still works like normal

    This happened shortly after a crash in the x axis that stopped the table from moving while under power feed but it worked for awhile after that so I don't know if it's related. I'll post pictures of...
  12. A long ass wire that goes outside

    A long ass wire that goes outside
Results 1 to 12 of 13