Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Jarrod

Search: Search took 0.00 seconds.

  1. Replies
    30
    Views
    8,466

    Might have been around 100 rpm. A tapped hole is...

    Might have been around 100 rpm. A tapped hole is a tapped hole, just use the correct type of tap and it's all the same.

    Next time I'm going to try out the tapping head!
  2. Replies
    30
    Views
    8,466

    I don't recall ever modifying the factory setting...

    I don't recall ever modifying the factory setting of my Leeson drive, except maybe the accel, because I'm impatient, but I can tell you I haven't had any issue power tapping on my BP. The Leeson's...
  3. Replies
    30
    Views
    8,466

    Damn skippy! You will run into current overload...

    Damn skippy! You will run into current overload or underload by sharing a single drive between machines, unless they are all the same horsepower/currnt rating and even then it's not advisable.
  4. Replies
    30
    Views
    8,466

    I gather you're going this route, since you don't...

    I gather you're going this route, since you don't have a 3-phase supply. If this is the case, there is no reason to get a 2 hp drive with a 1 hp motor, unless you plan on upgrading your motor in the...
Results 1 to 4 of 4