Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: mchasal

Search: Search took 0.00 seconds.

  1. Are the hole saws available with a flat on the...

    Are the hole saws available with a flat on the arbor? Maybe a MT4 endmill holder would work in that case. Though the sideload might be a concern as Peter says. ...
  2. Replies
    12
    Views
    1,078

    There's a pretty good pic in that auction link...

    There's a pretty good pic in that auction link that was posted earlier that shows the end of the turning bar:
    MultiTon equipment skate set with case, including for skates, two handles and four pad...
  3. Replies
    7
    Views
    881

    I've seen that setup you have, looks quite good....

    I've seen that setup you have, looks quite good. I'm curious if you've ever considered using something like the Footmaster casters with it? I keep toying with a setup like that, or just a pallet jack...
  4. Replies
    7
    Views
    881

    I think there is some variation though not sure...

    I think there is some variation though not sure if it's factory variation or people modifying them after the fact. Mine are tapped at 3/4x10 with leveling jack screws.
  5. Hi! I'm interested in: 1-H B&H caliper $25...

    Hi!

    I'm interested in:
    1-H B&H caliper $25
    2-U Mag holders $5
    6-B Squares $10

    I'd also be interested in 3-Unlabeled, mixed parallels. I see Halcohead spoke for those, but not listed as...
Results 1 to 5 of 5