Search:

R8 emergency collet

Drill chuck.

Ordered mine.

Kinda sums up life.

Quick story--

At an old job the customer was asking about some orders that we were behind on and my boss proceed to explain why we were running late on...

Don't know if this will help.
https://www.practicalmachinist.com/vb/cnc-machining/new-fagor-controller-does-not-like-smoothing-350047/#post3172141

If it just has to "work", I usually use a mating part so it screws on about 1/2" or so.
If you are going to use a gage, yes it screws on so that it is flush with the end of the part.

313467

(from the manual)

Do the best you can. Cut, check, adjust.

I just looked up my code and I'm using .078
Starting X is .906

Time flies like an arrow. Fruit flies like a banana.

Total Plastics in Middleburg Hts.

I think they have a $80 min.

^^This.

You are at Z.01 before the canned cycle and the first move you make inside it is Z.1 then Z-.94

Can't move different directions in Z.

I would never send something that looked like that to a customer.
Especially if I wanted to keep them as a customer.

312640
...

I feel bad for Mr Sami. He starts a legit thread and this will probably locked too.

Oh well. If at first you don’t suck seed. Keep on suckin’ til you do suck seed.

I hate when people call me Mr. Daily.
That was my dad, not me.

No not specifically. I HAVE had customers that wanted to send me more work but wasn't sure I could handle it.

I asked the customer if THEIR customers held work back, or do they just deal with it?...

Like the dogs that woof “Jingle Bells”?

Get one of these



312420

Stick it on the table and rapid a tool on top of the button til someone hits reset.

Subland Step Drills Manufacturer - Subland Drill (2-2) | RTS Cutting Tools, Inc.

I just chuck across the points like round bar. Seems to work fine.

Well, I’ve fought the good fight.
I imagine in 20 year I won’t much give a fuck anymore.
Time to pass the mantle.

I read where it was just light-duty vehicles.
I should still be able to buy a pick up truck that runs on gas.

312106

My quarantine ends tomorrow. I've been locked in the shop for the last 10 days.
No shipments, no deliveries. Just getting stuff done.

Best of luck to you.

Hard way: Adjust the headstock and/or tailstock.

Easy way: Program it out.

Don't know if this is what you're looking for but:

Press CURNT COMDS>EDIT>PRGRM CONVRS (press 3 times)

F2 (this will bring up all progs in mem. even hidden ones)

scroll down to O9996 and...