Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Gloryrates500

Search: Search took 0.00 seconds.

  1. Unfortunately i have also very old EPROM...

    Unfortunately i have also very old EPROM Versions.

    CNC V4.274/B
    SPS A4B092/93

    "aluminium sheet on the right side of D11 box"

    264669
  2. No, these aren't EPROM programs, these are the...

    No, these aren't EPROM programs, these are the files that are delivered with the machine, including the parameters.
    They used to be delivered with the orange folder, on two 3.5" floppy disks.
    Very...
  3. checkout that transistors on the left side of top...

    checkout that transistors on the left side of top card, if there is any damage visible as shown on the picture.
    The one on my picture is from a NZP03 card.

    247084

    You can also quick check the...
  4. good on you! So on the NPC are 4 EPROMs, type...

    good on you!

    So on the NPC are 4 EPROMs, type M27256F1/28pin. 2 as shown on your picture and 2 more under the smaller board on top.

    I have saved the EPROM software as follows, unfortunately...
  5. Thats exactly what i suspected, but there was no...

    Thats exactly what i suspected, but there was no readout fuse protection on my GALs.

    So i gave them a try and i was very happy to see that it worked fine.

    I think that in the 90s programmers...
  6. Vitran, there is no source where you can...

    Vitran,

    there is no source where you can download the EPROM programs except there is one owning the
    same type of machine like yours.
    Thats why it is so important to read out your own EPROMs to...
  7. Hi guys, i am reading in this forum for a...

    Hi guys,

    i am reading in this forum for a while and this is my first post. I am from Germany (homeland of Deckel and Grundig), so apologize my English.

    I have a FP4A running with Dialog 11.
    ...
  8. Hi, this is my first post in this forum. I am...

    Hi, this is my first post in this forum.
    I am from Germany and i have a FP4A with a D11 CNC - so apologize for my English...

    It looks like if the monitor in self test mode shows some errors and...
Results 1 to 8 of 8