Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: kingmichael427

Search: Search took 0.00 seconds.

  1. Replies
    31
    Views
    1,543

    Thanks Ross, I was aware of the reference point...

    Thanks Ross,
    I was aware of the reference point not being relevant to the machine function.
    The first thing I tried was G92 to set new coordinates.... then I read some of the programming manual....
  2. Replies
    31
    Views
    1,543

    The axis does not slow down before it searches...

    The axis does not slow down before it searches for the Reference point.
    I had the feed rate over ride at 10% and it still misses it.
    The slide moves away from the control panel (right to left)...
  3. Replies
    31
    Views
    1,543

    Okay, I am making progress. The X Axis is under...

    Okay,
    I am making progress. The X Axis is under control. Turns out that a dip switch was not in the right position. The Orange book that I have shows NZP x axis SB 6 as OPEN for the FP2NC.... the...
  4. Replies
    31
    Views
    1,543

    Thanks JZ79 - you have been very helpful so far. ...

    Thanks JZ79 - you have been very helpful so far.

    Ross - I tried to flip the scale. But there is no room for the cable to wrap back around. The X axis castings is machined with 0.020 Clearance for...
  5. Replies
    31
    Views
    1,543

    Harri89 - I switched the tach cables... Mode 5...

    Harri89 - I switched the tach cables... Mode 5 power on... X axis runs away in rapid mode. Took estop to abort the crash. so that's not it!

    JZ79 - Put jumpers on X11.1 & 2 Voltage increases to...
  6. Replies
    31
    Views
    1,543

    Disconnected X11.1 & 2, put a DMM on these two...

    Disconnected X11.1 & 2, put a DMM on these two wires to check for the signal.
    Started up in mode 5, hydraulic pump runs then machine shouts down. No commanded signal is seen.
    tried DC and AC...
  7. Replies
    31
    Views
    1,543

    I moved the Generated Phase to another leg no...

    I moved the Generated Phase to another leg no change.

    Mode 5 X axis starts moving Trips out at -32.977 and Position error 08 is in the highlighted box.

    Switch it to mode 16 and I see this: ...
  8. Replies
    31
    Views
    1,543

    ross, I don't see how the glass scale could be...

    ross,
    I don't see how the glass scale could be in backwards. The cable would not be routed correctly.
    Are you saying that the rebuilder flipped the read head around backwards?
    Michael
  9. Replies
    31
    Views
    1,543

    Okay, here is some more hints in this trouble...

    Okay,
    here is some more hints in this trouble shooting.

    mode #5 x axis moves away from the control panel. Moves left as your at the front of the machine.
    The Metal scale on the indicates 2" at...
  10. Replies
    31
    Views
    1,543

    Deckel FP2NC X axis run away

    Newbie on the FP2NC with Dialog 2 control.
    See if you can point me in the right diagnostic direction.
    When I start up in mode 5 the X axis moves by itself.
    Glass scales on X and Z axis were...
Results 1 to 10 of 10