Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: thunderskunk

Search: Search took 0.00 seconds.

  1. Tell me if I'm wrong in this assumption: G910...

    Tell me if I'm wrong in this assumption:

    G910 S1 H01 B3

    S*=#0 , H**=#1 , and B****=#2
  2. Sure: % O9010(AUTOMATIC TOOL OFFSET) (S.T...

    Sure:

    %
    O9010(AUTOMATIC TOOL OFFSET)
    (S.T X500.0 Y400.0 Z330.0+150+HC)
    (TOOL OFFSET MACRO PROGRAM V4.0)
    (G910 S* H** B*** D*** M0 )
    (CHANGE PARAMETER NO.6050 DATA 910)

    (START)
  3. To break it down a bit further, the exact issue...

    To break it down a bit further, the exact issue is the line where it rapid's down over the switch:

    G00Z-[#906-#900-#2-25.0](*)

    This comes up with a Z- overtravel alarm, which doesn't add up....
  4. Macro parameter settings for auto tool offset measurement

    Evenin' folks,

    OK, tool probe installed, level, wired, getting feedback from PLC DGN, life is good.

    I'm trying to set the silly thing up in the parameters. The manual says G900 is the distance...
Results 1 to 4 of 4