Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Jamie

Search: Search took 0.00 seconds.

  1. Replies
    17
    Views
    7,187

    DEAD STOP pin was sheared. With a good tug the...

    DEAD STOP pin was sheared. With a good tug
    the plunger fell out of hand wheel. Must have
    happened during shiping.
    Now I have Different problem, Our 1300EU Has
    sprung a leak from the work head,...
  2. Replies
    17
    Views
    7,187

    Problem found, solved and fixed. Thanks to all.

    Problem found, solved and fixed.
    Thanks to all.
  3. Replies
    17
    Views
    7,187

    Yes Mark, it has the fine feed ass'y (knob) but...

    Yes Mark, it has the fine feed ass'y (knob)
    but it still does it engaged or not.
    To do a fine infeed, you end up having to hold
    the hand wheel steady and try to fine adjust.
    One would assume that...
  4. Replies
    17
    Views
    7,187

    Wheel head floats as if on air. If I rapidly...

    Wheel head floats as if on air. If I rapidly
    rotate hand wheel then let go, hand wheel will
    continue to rotate 6 or 7 more revolutions.
    This will happen in either direction, and the
    weight will...
  5. Replies
    17
    Views
    7,187

    I did Check the chain & counter weight and...

    I did Check the chain & counter weight and
    they're in position and functioning properly.
    The problem is; when you release the handwheel
    it will drop to the bottom as if it's out ballence
    and...
  6. Replies
    17
    Views
    7,187

    Any One have any info on resolving cross feed...

    Any One have any info on resolving
    cross feed looseness?
Results 1 to 6 of 6