Search:

Its for a work stop, not sure Aloris sell those anymore. Google "Aloris Guide Stop"

When I ordered my complete 33 piece set of Triumph Twist Drill S&D bits they each came in a plastic sleeve along with a Huot rack for them.

If no one he comes up with one call H&W Machine in Ft Wayne IN. If anyone has M head parts machines its probably them. They can sell you the hand wheel but I would hold out for one on eBay if one...

I'd use CRC's "Lectra-Motive" Electric Parts Cleaner.

Try this.
http://vintagemachinery.org/pubs/2102/17983.pdf

The LeBlonde you are thinking of would be a Regal which is a lighter duty machine. This would be a 12 inch 'NB' Heavy Duty Engine Lathe. Produced from 1950 to 1957 this one is a 1956.

My Monarch 12CK has the original start/stop Westinghouse controls (in fact Westinghouse was the original owner) but the lathe also has a lever operated drum switch at the rear of the machine which...

Used on a horizontal milling machine. The "crane" allows you to remove an accessory head and "park" it on the machine.

269897

Actually the 2HL was 40 taper and the earliest 2H were apparently 40 also. Another early 2H feature was the lack of the overarm pinion to push the rams in and out. However by July 1940 the...

I have not run one but the biggest difference with the ACE is that instead of moving the work piece into the wheel (like a traditional surface grinder) you traverse the cutting head into the work...

What are the chances set number one went to someone with a YouTube or Instagram presence. When some of these guys post about a new tool you can watch the eBay prices jump.

The early machines had cast base (like a bell with a door in it), later machines were on pipe cabinets. If a machine differs it was probably transplanted due to damage or other requirements. As...

^^^ This ^^^

About testing oil flow... Running the machine with the head stock open will create an world class oil spill in an instant. Even in low gear that input shaft is turning its normal 800+ RPM. The way I...

Its my understanding the 12CK could be purchased with spindle speeds up to 1000 RPM. I wouldn't be too worried with running one that fast by playing with the motor pulley. Mine is setup for 800 RPM...

The stock motors were 1 HP 1750 RPM. They were designed to have a lower counter shaft speed of 300 RPM. Great drills. Mine had back gear issues. I replaced mine with a stock gears from...

I never ever recommend a novice use skates. I wouldn't ever think of using them on something that top heavy.

The short answer because people keep buying them.

+1

I think $250-750 is the likely sale price in the iron rich rust belt. At an industrial plant auction it would bring scrap at a weekend farm/estate auction more towards the top.

I found a 62" King listed as weighing 65,000. A Morey in the 96" range weighs 95,000.

Looks to be 1967

In addition to the face of the column look on the front of the knee. Many makers used that location for the SN. Very well could be painted over also...

There places in the headstock that don't drain by just pulling the plug. If there is any doubt I would pull the headstock cover. A turkey baster is an excellent tool to clean the oil and allow you to...

What I see is the same type of wear I see in my 12CK however much more extreme. Looks like years of the same user or users slamming the dog clutch into gear. Picture #1 clearly shows the amount of...

Great machines, my favorite to operate. If its a good machine it should be pretty quiet when operating. Here are some quick instructions if you've never run a K&T. Make sure the motor is running the...