Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: john.k

Search: Search took 0.01 seconds.

  1. Replies
    65
    Views
    8,067

    You should have min of 25 hot @ 1800,and cold...

    You should have min of 25 hot @ 1800,and cold around 50......the oilpump is a rotor around the front of the crank,so unless the filter is missing,virtually impossible not to have oil pressure...
  2. Replies
    65
    Views
    8,067

    The Ford V8 had a very complicated block because...

    The Ford V8 had a very complicated block because the exhaust ports were on the outside edge ,while the valves were on the inside of the V .....most other V8 flatheads had the exhaust manifolds on the...
  3. Replies
    65
    Views
    8,067

    No glow plugs in a GM,if you need heat for a...

    No glow plugs in a GM,if you need heat for a start ,then the choice is a giant flamethrower in one of the airbox handhole covers ,or a ether capsule unit......we used to start the GMs in freezing...
  4. Replies
    65
    Views
    8,067

    Assuming JH1 new toy has a 3.1 or 3.5 axle...

    Assuming JH1 new toy has a 3.1 or 3.5 axle ratio,he ll be cruising the interstate at 100mph....like Smokey and the Bandit on roids.....steroids that is ,not the other kind.
  5. Replies
    65
    Views
    8,067

    I had two 1982 Fords with silver 6v92 TAs on...

    I had two 1982 Fords with silver 6v92 TAs on contract towing animal feed pressure tanks.In the Fords ,the motors were accessable ,unlike the same trucks with BC Cummins ,where 2/3 of the motor was...
  6. Replies
    65
    Views
    8,067

    JH1 s motor is a silver 92 with DDEC.....this is...

    JH1 s motor is a silver 92 with DDEC.....this is one of a small select group of diesels with specific fuel consumptions under 200gm /KWH....even the best Euros only got marginally below this.In fact...
Results 1 to 6 of 6