Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Peter S

Search: Search took 0.02 seconds.

  1. Replies
    10
    Views
    2,250

    GinoS, How did you get on. Was any of this...

    GinoS,

    How did you get on. Was any of this information helpful?
    Also wondering why you would want to cut 92 TPI...:confused: :)
  2. Replies
    10
    Views
    2,250

    For any Sag 14 owners interest - the manual I...

    For any Sag 14 owners interest - the manual I have is slightly different to the on-line digital copy, and has a more readable image of the screw-cutting/feeds charts.

    There were two options for...
  3. Replies
    10
    Views
    2,250

    GinoS, Good news! If you have the correct...

    GinoS,

    Good news!

    If you have the correct gears that is...

    I had a look at my Sag 14 manual and found it is slightly different to the digital copy manual above (I think my manual is a...
  4. Replies
    10
    Views
    2,250

    I know that module and DP apply to gears, but the...

    I know that module and DP apply to gears, but the question is why these terms are found on a lathe. OK, for making a worm. Not something I know anything about either - I have used lots of worm...
  5. Replies
    10
    Views
    2,250

    Hi GinoS, I think you are looking at the...

    Hi GinoS,

    I think you are looking at the charts on the right hand side, which are for "Module" and "Diametral Pitch".

    I don't understand what those charts are for, but the '92' you are looking...
Results 1 to 5 of 5