Wanted: face plate for Seneca Falls lathe- 2" X 12 TPI

Andy FitzGibbon · Jan 2, 2006

I need a face plate for my Seneca Falls. The spindle threads are 2" X 12 TPI. The swing is right at 12" , though if you have something bigger that can be cut down that would be fine. I'd be interested in any sort of face plates, chuck plates, or dog driver plates.
Thanks,
Andy FitzGibbon
[email protected]
304-637-2857

toolingking · Jan 3, 2006

andy: i checked my stock of back plates etc and have nothing. all i can offer you is a new 2"-12 hss ground thread plug tap. $70.00. kenny

Andy FitzGibbon · Jan 3, 2006

Hi Kenny,
Thanks for looking- I'll keep the tap in mind.
Best,
Andy

Andy FitzGibbon · Jan 5, 2006

Duh- I put the wrong email address in the ad. My new (and correct) address is [email protected]
Thanks,
Andy

aametalmaster · Jan 5, 2006

Andy, I have some 10" cast iron blanks which can be lathe threaded for your machine...Bob
http://pg.photos.yahoo.com/ph/aametalmaster/album?.dir=2ce4&.src=ph&store=&prodid=&.done=http%3a//photos.yahoo.com/ph//my_photos

Search

Largest Manufacturing Technology Community on the Web

Search

Wanted: face plate for Seneca Falls lathe- 2" X 12 TPI

Andy FitzGibbon

Diamond

toolingking

Cast Iron

Andy FitzGibbon

Diamond

Andy FitzGibbon

Diamond

aametalmaster

Diamond

Similar threads